Used to be the socket with micro USB, but USB c is much more resilient. And any damage usually occurs on the cable end and not the socket. So worst case just replace the cable

Literally better than anything I could do

You're welcome! Well it's more complicated than that, and I'll be honest I don't THOROUGHLY understand everything about it.

But the idea is to move the liquid from one canister to the other, that's why the "giving" canister is upside down. But because you're moving the liquid itself, you can accidentally fill the entire canister with liquid, no room for the vapor to expand into when it gets warm, and boom! So be careful. As long as you weigh it you'll be safe 👍 You freeze the receiving can because cold gas has a lower vapor pressure. And you can put the giving can in a bowl of warm (not hot!) water to increase it's pressure and make the transfer happen faster. You'll feel the giving can get cold as you fill the bottom can.

Fun fact, this is how air conditioners work! Take any gas (preferably not flammable, but that exists too), decompress it in a pipe so it boils into a vapor and absorbs a bunch of heat, making the pipe cold and you can blow air over it to cool your house or fridge.

Then that boiled gas vapor goes into a compressor that increases the pressure in a second pipe, enough that the gas has no choice but to condense into a liquid again. This releases all the heat that was captured in the boiling phase. Now you've got a hot pipe, and you put it outside and blow air over it to cool it off, further liquifying it. Then you take the liquid and release it back into the low pressure boiling pipe inside and start the process all over again!

Nice! I didn't know this existed!

Yes mine does canister to canister as well 👍👍

A special adapter from Amazon, like $20.

Be sure to refill by weight. Buy a full screw top canister and weigh it with a kitchen scale, note the weight in grams, write it on the can and in your phone.

Then later, when it's empty, put it in the freezer for several minutes, pull it out and refill it with the other canister, but only fill it to the weight it was originally at. It will gladly take more gas, but there will be less headroom or no headroom, and the canister has a high chance of exploding.

The Internet will tell you not to do it, and how unsafe it is, how the valves aren't meant for that many uses, and it's definitely gonna explode etc etc. But if you do it smart, you're fine. And don't reuse the same screw canister many many times, you're already saving money, reuse it a few times then recycle it and start over.

Edit: this is the one I bought, it'll do the trick. https://a.co/d/eHJDQGL

Also NEVER EVER EVER refill them with any amount of propane! Yes the normal canisters come with a percent of propane in them to help in cold weather. But getting the partial pressure mixture right is almost impossible at home, and propane will definitely make your canister explode. It's vapor pressure is too high. That's why the pure butane canisters are so thin, and the green pure propane canisters are so thick and heavy, because they need to be to hold back the pressure.

I've tried it as mouse, I've tried it with left trigger activateb and touch right stick activate and always active

I meant on purpose as in to remove gyro aim for some reason. Though I don't think so, apparently forbidden west has native gyro support.

It's ok if my old profile is invalid, but why is it now not possible to set up gyro again?

It looks like hers got nuked too, it's on the "official" input scheme, and there's no sign of my previous setup, and gyro is off.

I'm hoping this wasn't a intentional change made by the have developer, that would make me pretty salty

Good idea! My last playthrough was on my wife's account, this time I'm borrowing it on mine. I'll try to go back and see what hers is.

Bidet master race.

Got myself one with heated seat, heated water (tankless water heater, not a connection to a hot water tap that takes ages to warm up), and even a hot air dryer thing that I only really use in the winter.

Cost a hundred bucks, best hundred bucks I've ever spent, I'll never go back.

Cold water ones are good too, more practical even, but the water gets cold here in the winter, make your brown eye blue lol

Some people like tinkering. Big Clive has a series of videos on Dubai led bulbs. The government mandates that the bulbs be extra efficient and last extra long, so they are built with more filaments driven at a lower current. They run cooler and last longer. You can do a similar thing with American bulbs if you're handy with a soldering iron.

Honestly, with how poor many of these things are mass produced, opening them up yourself is practically a personal form of quality control. Whether you modify it or not I bet it's less likely to die prematurely or burn your house down than those of a regular person who doesn't open them 🤷‍♂️

I'm reasonably excited. I like the steam deck, and I'm off the opinion that we don't need an updated version just yet. A slower moving target for developers is best for long term game compatibility.

But eventually a new steam deck will arrive, and it will likely use the latest CPU/GPU, which will likely benefit from this new frame generation technology.

And perhaps some benefits will trickle down to the current steam deck, or maybe not 🤷‍♂️

But still, I'm optimistic for the future of mobile gaming.

Thanks!

Ok that's great to hear. Basically it functions perfectly fine so long as you aren't stressing the system.

Nice research! Thanks!

That makes sense. I'm pretty sure all my chargers support voltages up in the 20s, I forget what the standard is. So perhaps that's the main factor.

Thanks for your input!

Interesting, so perhaps it could be an issue. I'd be curious to find out!

Hmmm, well USB PD is pretty universal and I imagine that's what framework uses?

18w is pretty low, I agree and I wouldn't expect that to work. But the 13 inch framework uses a 65w power supply so it certainly seems in the realm of possibility. To me anyway.

I'd love to know if anyone has tried it

That's fair. I figured as much. I'm still doing most of my couch computing on a 2016 Chromebook. It calls for a 45w charger, but I've used my 18w phone charger in the past. It complains about it, but it still slooowly charges.

I was hoping the framework would fare better on 65w.

Again, not a big deal, just a talking point. Easily solved problem. Just curious. Thanks!

Eh it works just fine 🤷‍♂️